EVO Surface Wall Mount Installation Instructions
PM0437-02
EVO SURFACE WALL MOUNT INSTALLATION INSTRUCTIONS
PAGE 1 OF 2
EVO Surface Wall Mounting
CONTENTS:
QTY PART
#
DESCRIPTION
1 MW0804-01
BOTTOM
TOWER
COVER
4
HW4559-03
1/4 – 20 x. 50L PAN HEAD PHILLIPS MACHINE SCREW
NOTE: THIS INSTALLATION SHOULD ONLY BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN.
To mount the EVO on a wall follow the instructions below.
NOTE: If you are mounting the EVO on the wall, the wall must not be a structural, or
load-bearing wall.
EVO with Coin:
If you are installing the EVO on the wall, a quick adjustment to the coin mech is
required for proper operation of the mech. Follow the instructions below to adjust the coin mech
before continuing with the installation instructions. For EVOs with bill acceptors only, continue
with the installation instructions on the reverse side of this sheet.
1. Unlock and open the cash tower.
2. Using Figure 1 as a guide, pull the bottom tabs on the coin mech out of the back notch on the coin
mech bracket and place the bottom tabs on the coin mech in the front notch on the bracket. The top
tabs should remain in the back notch.
3. Close and lock the cash tower and continue with Surface Wall Mount Installation Instructions on the
reverse side of this sheet.
NOTE: If you change the mounting of the EVO to table or bar top mounting, you must return the
coin mech to its original position.
FIGURE 1 - PROFILE OF COIN MECH BRACKET
BAR
MOUNT
WALL
MOUNT